photo

 

Thul Specialty Contracting is the exclusive supplier and applicator of PPC Coatings in the Upper Midwest.

 

PPC Coatings

PPC Coatings Polymorphic Polymers are highly modified rapid curing thermoset resins, applied to new and old concrete, steel, and fiberglass structures that require long lasting protection in severe corrosive and abrasive environments.

image

Since 1984 PPC has successfully passed testing for waste water treatment application per Los Angeles County Sanitation District’s “Evaluation of Protective Coatings for Concrete.” PPC Coatings have been approved for contact with potable water by EPA and for application in the food processing industry by USDA and CDA.
PPC Coatings can be applied year round, in extreme temperatures, ranging from minus 40°F to plus 160°F without the need for external heat assistance. Coatings cure within minutes to an hour, rapidly returning the area to service, saving expensive “down time”.

  • Rapid curing coatings applied all year round
  • High flexural and compressive strength, excellent mechanical abrasion resistance
  • Resistant to a wide range of chemicals and U.V.
  • PPC Coatings have a coefficient of thermal expansion similar to that of concrete
  • Simple application by brush, roller, trowel and spray

Prime Coat:

image

Prime Coat must be applied to a sufficiently prepared surface. PPC Prime Coat must be applied and thoroughly worked into all substrates to be coated. The approximate coverage rate of PPC Prime coat at 7-8 Mils is 160sq/ft per gallon.

Intermediate Coat:

IC-Q intermediate Coat must be applied to a clean dry Prime Coated surface. IC-Q should be applied at a minimum thickness of 30 Mils and can be built up as a much thicker application with a trowel. IC-Q intermediate Coat is used to fill joints, bug holes, holidays and voids in the concrete substrate. The approximate coverage rate of IC-Q intermediate coat applied at 30-40 mils is 40sq/ft per gallon.

Final Coat:

All coats applied with IC-Q Intermediate Coat must be coated with a Final Coat. Final Coat can be a clear coat or a colored coat. The approximate coverage rate for PPC Final Coat applied at 8-10 Mils is 150 sq/ft per gallon.

PPC Coatings are resistant to a wide range of chemicals as well as U.V. rays, making PPC suitable for outdoor exposed applications. The high flexural strength of PPC coatings makes them suitable for tanks and steel structures. PPC Coatings provide outstanding impact and abrasion resistance for protection against heavy equipment and abrasive traffic. PPC Coatings have excellent bonding characteristics to concrete and steel, and with a coefficient of thermal expansion similar to concrete, PPC is resistant to cracking and delamination caused by thermal shock.

PPC Coatings are 100% solids without solvent entrapment after cure, which meet or are well below the maximum VOC emissions requirements. PPC Coatings have zero linear shrinkage.

PPC Coatings have stood the test of time. For over 30 years Polymorphic Polymers have successfully been applied and tested in the harshest conditions by government agencies around the world.

 

Thul Specialty Contracting is the exclusive supplier and applicator of PPC Coatings in the Upper Midwest.


Back to all Services